Tennsco L&T - Manual (Page 4)

9
10
10
11
12
13
14
15
12
26
25
FRONT UNIT MIDDLE UNIT
REAR UNITS
END VIEW OF UNITS AFTER THEY ARE COMPLETED
STEP 6) Place the Deck Covers (#9) into the open portion of the Track Assembly. They are approximately 6" x 36" or
48" and have a ribbed safety vinyl laminated to the surface.
STEP 7) Place the Track Assembly (#2) next to the L&T unit that has been pre-installed. Place the Track Spreader
Panel (#10) over the Track Assembly sections as shown. Insert the Deck Covers (#11) into the Track Spreader Panel.
STEP 8) Slide the Ramp Plates (#12) onto the front of the Track Assemblies.
STEP 9) At both ends of the floor assembly, attach one end of the Track End Plate (#13) to the End Plate Angle (#14)
using two (2) machine screws (#15). Then attach this assembly to the end of the L&T unit section. This will insure that
this floor assembly does not move.
Stabilizer Support
Angle for Front Unit
Stabilizer Cover
Roller Bracket
Assembly
Stabilizer Roller
Bracket Assembly for
Middle Unit
End View
9
10
2
3 3
1
8
8
11
Enlarged End View
24
24
26
25
Stabilizer Support
Angle for Front Unit Stabilizer Cover
Roller Bracket
Assembly
Stabilizer Roller
Bracket Assembly for
Middle Unit
FRONT UNIT MIDDLE UNIT
REAR UNITS