Tennsco Z-Line Medium Profile Shelving - Manual (Page 3)

7. Attach the remaining
shelf supports at the
desired shelf levels.
9. If particleboard (Ref. No. 5a) or wire decking
(Ref. No. 5b) was
purchased, place
the decking on
each shelving level.
Particleboard should
fit flush inside the
shelf supports,
while wire decking
will sit slightly
below the shelf
support edges.
If you purchased
a single unit,
your shelving unit
is now complete.
For adder units,
see step 10.
6. With the help of an
associate, connect
the two unit ends
with left-to-right shelf
supports (Ref. No. 3).
10. If joining more than
one unit together, your
original unit should have been
assembled with ZTP uprights on one end, as
described in step 5. Simply
continue adding shelf
supports and uprights
to complete your
additional units.
Every 4th hole
is flattened at top
NOTE: Every fourth
keyhole slot is shaped
with a flattened top as
shown below. This
makes alignment of
shelf supports easier.
8. If assembling with optional front-to-back deck
supports (Ref. No. 4), install now at each desired
shelf level by placing across the
opening between the two left-
to-right shelf supports and
inserting the tabs into the
slots provided.