Tilton Premium Bias Adjuster (98-1271) - Manual (Page 2)

13. Thread the coupling onto the hex broached or longer end of the balance bar shaft. Typi-
cally, this is on the right side. Tighten jam-nut against coupler.
(900 series balance bars do not require a coupling)
14. Insert the cable end into the coupling and secure the cable by tightening the set-screw in
the coupling. For the 900 series balance bar, the cable goes directly into the balance bar
end and is secured using the set screw located in the balance bar itself.
15. Secure the cable along its route with the six (6) cable clamps that are included in the kit.
Less cable housing movement provides better balance bar adjustment and more percise
movement. Make sure the balance bar end is free to move throughout the range of the
brake pedal.
16. Rotate the adjustment knob and observe the direction and effect it has on the balance
bar position. Rotating the balance bar so it shifts towards the master cylinder for the rear
calipers increases the amount of rear braking.
17. Apply the proper directional decal on the adjustment knob according to
previous observation (Diagram 5).
MaIntenance
• Periodically inspect the balance bar assembly and the Remote Cable Adjuster.
• Lubricant should not be used for the cable, but could be used on the detent mechanism
and knob shaft. Use a light oil.
• Lubrication is not recommended for the balance bar since dirt and other foreign particles
that can hinder operation tend to stick to oil and grease.
technIcal
¼ or full Turn of Knob = % Bias Change (Chart 1)
DIs-asseMbly:
1. Remove retaining clip and washer and place hand over assembly to retain the ball and
spring assembly.
2. Pull the knob from the base until the ball and spring assembly comes out
Warning: Ball and Spring assembly under Preload.
asseMbly:
1. Slide the knob with the large washer into the base and align the cross hole of the knob
with the slot on the base (Diagram 2).
2. Position the knob far enough into the base so to retain the first ball inserted into the
cross hole of the knob.
3. Follow this with the spring and second ball (Diagram 3). Using a pointed object or finger,
recess the second ball into the cross hole and gently push the knob into the base.
To finish, install the small washer and retaining clip (making sure the clip is in the groove).
(See Diagram 4)
Diagram 2
Diagram 3
Diagram 4
Diagram 6
Balance Bar Size Clevis Center to Center Distance 1/4 Turn Full Turn
3/8" x 24 2.5" 0.42% 1.67%
7/16" x 20 2.62" 0.48% 1.91%
1/2" x 20 2.75" 0.45% 1.82%
Chart 1
% Bias Change
Diagram 5
Tilton Engineering, Inc. 25 Easy Street • PO Box 1787 • Buellton, CA 93427 • www.tiltonracing.com