Trail Master 2.5 Inch Lift Kit with Shock Extension Brackets (TM3325-40010/TM3325-40013) - Manual (Page 6)

6
Save the hardware for reuse.
7. Unclip the ABS line from the axle.
8. Lower the rear differential so that the springs
come loose. Remove the OE coil springs and
the OE isolators. Label the springs as to which
side they were removed, Left and Right so that
they are reinstalled in the side in which they
were removed.
Install Rear Suspension
1. Install the coil spacer mounting nut (82-
TM20009) on top of the coil bucket.
2. Install the rear coil spacer (82-TM30002) into
the upper coil bucket. Secure the rear coil
spacer to the mounting nut using the 12mm X
75mm fully threaded bolt and hardware.
3. Reinstall the coil springs and the previously re-
moved OE isolators into their respective upper
and lower spring perches.
4. Raise the rear differential and make sure that
the coil springs are in their saddles.
5. Reinstall the OE rear track bar to the axle mount
using the previously removed OE hardware.
Torque the track bar mounting bolt according to
manufacturers specifications.
6. Reconnect the lower sway bar links to the axle
using the previously removed OE hardware.
7. Now would be a good time to inspect the rear
shocks for damage or fluid leakage. Replace if
necessary.
8. If you purchased kit TM3325-40010, install the
upper rear shock and extension bracket (82-
TM30005) to the upper mount using the sup-
plied 10mm X 80mm bolts and hardware.
9. If you purchased kit TM3325-40013, install the
new rear upper shock (TM73245004) mount to
the upper mount using the previously removed
OE hardware.
Rear Upper
Coil Pocket
Rear Upper
Coil Pocket
82-TM20009
Mounting
Nut
12mm X
75mm Fully
Threaded
Bolt
82-TM30002
Rear Spring
Spacer