Trail Master 6.0 Inch Knuckle Suspension Lift Kit with Rear NGS Shocks (TM407N) - Manual (Page 14)

14
TM407N
Revised
6.14.13
f. Install OE coil seat, kit striker pad and OE
bump stop onto new strut in same fashion as
originally removed from OE strut.
g. Using coil compressor compress coil and
slide strut into position until threads are ex-
posed through top. Secure with nut.
11. Install shocks
a. Install three upper studs into factory
pocket and secure using OE nuts removed
during disassembly.
b. Pivot lower control arm up and in line with
lower strut mount, secure with OE bolt re-
moved.
12. kit knuckle on vehicle.
a. Insert upper and lower ball joints through
kit knuckle and secure using OE ball joint
nuts. Do not tighten at this time.
Kit Bushings
Kit Sleeve
OE Spring Pad OE Bump stop
Kit Striker pad
Lower mount
using OE bolt
Upper mounting studs
& nuts Lower mount
using OE bolt
Upper
Ball joint
Lower
Ball joint
Kit
Knuckle
241001
Drvr and
241002
Pass
Kit Strut
75700
Kit Strut
75700