Triangle Engineering of Arkansas Golf Fans HV 24 and 30 - Manual (Page 3)

Page 3
JETAIRE MOUNTING BRACKET ASSEMBLY
INVERTED BEAM MOUNTING
This installation requires the purchase of the
OPTIONAL MODEL "VMB 2430"
VERTICAL MOUNTING BRACKET
(Note the "D" dimension as shown on Manufacturer's Literature)
– – – – – – – – – – – – – – – – – –
• Weld or bolt Hanger Bracket to horizontal beam.
Bracket must be located a minimum of 24" from
walls and other vertical obstructions.
• Using ONE 1 ⁄
2
" x 1" bolt with nut, attach Upper
Support to Hanger Bracket.
• Attach extension tube to Upper Support with
TWO 1 ⁄
2
" x 1" bolts and nuts.
• Lift JetAire into position and attach the Lower
Support to Extension Tube with TWO 1 ⁄
2
" x 1"
bolts and nuts.
• Turn JetAire in desired direction and place 5 ⁄
16
"
x 1" carriage bolts and nuts in slots of Hanger
Bracket and Upper Support. BE SURE ALL
BOLTS AND NUTS ARE TIGHT.
• Loop safety cable around fan yoke as shown on
right and attach opposite end to beam.
The "HV" fan(s) you purchased are supplied with
either the Standard Mounting Bracket or the Optional
Oscillating Assembly.
• To attach either of these to the fan yoke, simply
match the four holes in the yoke plate to the four
holes in either the cap(2) or the oscillator
assembly.
• Insert the four bolts (3), install nuts and tighten.
• Your JetAire may now be assembled to the In-
G round Post, Pedestal, Horizontal or Tre e
Mounting Bracket.
• NOTE: Before attempting to install your fan on
any of these mounts, it will be necessary to
loosen set screw (1), as shown on right, so that
the point does not protrude into the I.D. of the
cap.
• With the JetAire installed on the mount and fac-
ing the desired direction, tighten set screw.
TILT ADJUSTMENT
To tilt the JetAire, loosen bolts (4) on each side of
yoke, position fan and retighten bolts.