Triton 96XX CASH DISPENSER CABINET Installation Manual - Manual (Page 4)

TRITON SYSTEMS, INC.
96XX CASH DISPENSER CABINET INSTALLATION GUIDE
4
Mark the location of the cabinet mounting holes on the concrete
floor. This can be accomplished in two ways, as described below:
1a. Preferred Method. Place the included mounting hole drilling
template on the floor in the designated location and tape it into
position.
Be certain there are no physical obstructions that
could prevent the cabinet from being installed in this
location, or otherwise limit access to the unit!
Use a center punch tool (or equivalent) to mark the center of
each mounting hole, as indicated on the template. Remove
the template.
1b. Alternative Method (Business Hours Units). Move the Cash
Dispenser to the location where it will be installed.
Open the cabinet door at least 90 degrees to improve access.
Locate the four anchor-bolt holes (cutouts) in the bottom of the
cabinet. Use a felt-tip pen or other marker to carefully mark
the center of each of these four holes on the floor; these marks
will serve as guides for the anchor bolt holes that will be drilled
in the next step.
Move the Cash Dispenser aside, to provide clear access to
the mounting hole marks.
2. Use a 1/4-inch diameter carbide-tipped masonry bit to drill four
pilot holes at the drilling points marked in the previous step.
Drill the pilot holes approximately 1/2-inch deep into the floor.
These holes will help guide the half-inch masonry bit that will
be used to drill the anchor-bolt holes in the next step.
3. Use a 1/2-inch diameter carbide-tipped masonry bit to drill four
holes at least 2 3/4-inches deep into the floor. Be sure to take
into account the depth of any floor covering, such as tile or
vinyl when gauging the depth of the anchor holes.
Make sure
the holes are drilled at least 2 3/4-inches into the concrete
floor.
4. Use a portable vacuum cleaner to remove any dust or debris
that may have fallen into the holes during the drilling process.
**IMPORTANT**
Use a pencil or measuring rod to check the depth of each
hole; the depth of each hole must be at least 2 3/4-inches
before continuing!
LEVELING FEET
The leveling feet included in the
cabinet installation kit are for op-
tional use with the Business Hours
Service cabinet.
Follow these steps to install and
adjust the leveling feet:
1. Screw the leveling feet
completely into the four
threaded bosses in the base of
the cabinet. If necessary, lay
the cabinet on its side to access
the bosses.
2. Once the cabinet is in the final
mounting position use a
screwdriver to adjust the
leveling bolts.
DO NOT extend
the feet any further than
necessary to level the
cabinet! Use a bubble level, if
available, to verify the cabinet
is level.
3. After the mounting bolts have
been tightened, ensure the
cabinet door can close without
binding.
It may be necessary
to adjust the tightening of the
mounting bolts to enable the
door to close without
binding.
If leveling feet are used the cabi-
net bottom may experience warp-
ing or bending when the mount-
ing bolts are tightened down! This
may prevent the cabinet door
from closing cleanly!