Triton 8100 User/Installation Manual - Manual (Page 90)

72
M
ODEL
8100 U
SER
/ I
NSTALLATION
M
ANUAL
N
OTE
C
ONDITION
If possible, store currency at room temperature for at least eight hours before
dispensing from the cassettes.
The number of rejects can be directly influenced by the technique used to load
the cassettes and the quality of the currency. Notes loaded into the cassettes
must be in “fit” condition if a high level of performance (low reject and failure
rate) is expected from the unit. “Fit” notes do not possess any of the defects
listed:
D
ISPENSING
M
ECHANISM
The Model 8100 ATM uses a TDM-50 dispensing mechanism. The recommended
capacity is 400 notes. Currency capacity depends on the note quality and thick-
ness.
The dispensing mechanism delivers the appropriate number of notes from the
note cassette to fulfill the customer’s withdrawal request. The purpose of the
reject area or cassette is to accept and hold notes that have been transferred from
the note cassette but not dispensed. Some situations that could cause the mecha-
nism to reject notes are: (1) multiple notes stuck together and (2) note width too
short or long. Other conditions that could cause a reject are described in the next
section, Note Condition.
I
NTRODUCTION
The purpose of this section of the manual is to describe the procedures for
cassette closing and replenishment.
Information concerning note handling and quality issues are explained initially.
**WARNING**
DO NOT RECYCLE REJECTED NOTES INTO A CASSETTE!
Doing so could cause more rejects and/or currency jams.