Triton MAKO PEDESTAL Installation Manual - Manual (Page 4)

4
TRITON SYSTEMS, INC.
MAKO CASH DISPENSER PEDESTAL INSTALLATION GUIDE
LEVEL THE CABINET
Use a screwdriver to screw all four leveling feet in so
they are flush with the bottom of the cabinet.Use a
bubble level to check the leveling (Figure 4). If neces-
sary, adjust one or more of the feet slightly to achieve a
level base (Figure 5),
keeping the feet as close to the
bottom of the cabinet as possible . When done, the
cabinet should be resting evenly on all four feet, and
should not rock or tilt in any direction.
DRILL PEDESTAL MOUNTING HOLES
Locate the four hole-cutouts in the metal frame of the
pedestal base and use them to mark the drilling points
for the pedestal mounting holes.
If the optional security chain is to be installed, place any
one of the chain-anchor plates inside the large cutout in
the center of the enclosure floor. Center the plate be-
tween the left and right sides of the cutout, then push
the plate to the back edge of the cutout, as shown in
Figure 6. Mark the drilling points for the chain anchor
plates, which will be installed in a later step.
Close the security cabinet door and move the pedestal
(and chain anchor plate) aside to provide clear access
to the mounting-hole pattern. Drill four 1/2" holes, at least
three inches deep, into the concrete flooring at the ped-
estal base locations marked earlier. Next, drill each hole
to a depth of two inches, using a 3/4" bit. (See Figure 7)
4
3
Fig. 7
Fig. 6
Fig. 5
Fig. 4
Leveling Foot