Triton FT5000 PC-BASED ATM Installation Manual - Manual (Page 40)

40
Figure 3. Route cables through access
holes. Install snap bushing.
4. Install the supplied snap bushing
into the access hole that carries
the power and phone cords. See
Figure 3.
5. Plug the AC power plug into the
wall outlet.
2. Open the security vault door .
Ensure the power and Ethernet
cables are routed through the
cable clips located in the vault
cabinet (Figure 2).
3. Route the AC power cord and the
Ethernet (CAT-5) cable through
either of the cable access holes
(as applicable) in the security
cabinet, as shown in Figure 3.
Figure 2. Power and Ethernet cables
secured to cabinet.
FT5000 XP - S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
C
ONNECTING
AC P
OWER AND
E
THERNET
C
ABLE
1. Unlock and open the control
panel sleeve door. Rotate the Rear
Service Display and Keyboard
Assembly out by pulling down
the locking pin. Verify that the
power switch located on the
power supply (Figure 1) is in the
OFF (0) position. Close the
control panel door.
Figure 1. Ensure power supply is in
the OFF (0) position.
* IMPORTANT *
AC power for the terminal should
come from a dedicated source with
an isolated ground.
6. Plug the Ethernet (CAT-5) cable
into the wall mounted jack.