U.S. Sunlight 8912VK Garage Ventilation Kit - Manual (Page 2)

Step 3
Hook the end loop of wire of the flexible tube to the notches on the collar (fig.4).
Duct tape the flexible tube to the two collars (fig.5).
Step 4
From underneath, insert one collar into the tunnel of the solar attic fan (fig.6a), and rivet in place (fig.6b). From the outside,
seal rivet heads with silicone (fig.7).
* Install the U.S. Sunlight Roof Mounted Solar Attic Fan per normal instructions.
Step 5
From inside the attic, determine the desired location, center a nail or piece of wire between the ceiling joists and through the
ceiling so it is visible from below (fig.8). Use the ceiling frame as a template and draw the hole to be cut (fig.9). Begin cutting
the circle with a drywall saw (fig.10).
Fig. 4
Fig.5
Fig. 6a
Fig. 6b Fig. 7