U.S. Sunlight 2014ST Light Kit - Manual (Page 2)

Prepare the socket cord length
The Socket Assembly comes with 48” of cord. We have included a 9 3/8” length of standard
3/8” flexible conduit which is adequate for locating the junction box within 6” of the outside
of the tube material (fig. 1 & 2) If you require a longer length, simply purchase the correct
amount of flex conduit from your local hardware or builders supply.
3/8” flexible conduit
Flex Tube
Rigid Tube
within 6”
Socket Assembly
If your installation is not as indicated in (fig. 1 & 2) skip
steps 1 & 2 below and wait to shorten cord to the length
you need after you have secured the Junction Box as
described in Step 17.
fig. 1 fig. 2
Assemble the Light Kit
Step 1
To install the Light Kit with the supplied flex conduit, cut
the cord of the Socket Assembly to a 20” length (fig. 7)
and (fig. 3 & 4)
Step 2
Using a utility knife, cut into the outer sheathing to access the two
shielded wires (fig. 5) Using wire strippers, strip the wires open to
about 1/2” then twist the strands (fig. 6) to prep for connecting to
the AC source. The resulting alteration should look like (fig. 7).
fig. 3 fig. 4 fig. 5 fig. 6 fig. 7
fig. 8 fig. 9 fig. 10 fig. 11 fig. 12
Step 3
Remove the nut from the 90° Connector (fig. 8) Then loosen
and remove the screws of the hold down plate and remove
the plate. (fig. 9)
Step 4
Insert the wire end of the Socket Assembly into the smaller hole on
the Connecting Bracket (fig. 10) Then insert the Threaded Nipple
and Locknut onto the wires (fig. 11) Finally, the nut from the 90°
Connector. (fig. 12)
fig. 13 fig. 14
fig. 15 fig. 16
Step 5
Screw in the Threaded Nipple into the Socket until it stops, then
tighten the locknut (fig. 13) Then insert the 90° Connector onto the
wire and tighten the nut (fig. 14) Bend the cord down and reattach
the hold down plate and screws. (fig. 15 & 16)
For best results position the
parts as indicated in (fig. 17)
fig. 17
20”