U.S. Sunlight 9910TRP Solar Panel - Manual (Page 3)

Wall mounting:
Brackets are included to mount the panel to a wall if preferred.
First, assemble the braces to the brackets as follows:
Step 1.
Attach the brace to each bracket with the cross brace bolt and nut (E.) (fig. 11)
Step 2.
Attach the brackets to the panel using the 4 bolts (F.) (fig. 12)
Step 3.
Depending on the material your wall is made of, mount the assembly to the wall using appropriate fasteners
(see “Optional Hardware” on page 1 for details). (fig. 13 and 14)
fig. 11 fig. 12 fig. 13 fig. 14
see Optional
Hardware on
page 1
bolt F
Connecting the motor and two panels
with the Y-Adapter
The Y-adapter allows 2 solar panels to be connected in parallel to the motor. This
does not double the voltage to the motor - it simply provides another power source to
allow the unit to operate for a longer period of time during the day.
Step A2.
Connect the leads from the second panel (fig. 16) to the
Y-Adapter in the same fashion. If necessary, use a piece
of electrical tape to cover the black leads so they don’t
touch the red leads when everything is connected.
fig. 15 fig. 16
fig. 17 fig. 18
connect
to the
motor
fig. 19
Step B2.
Disconnect the panel leads from
the motor leads. (fig. 21)
Step B3.
Now connect the Y-Adapter as
described in steps A1 - A3 to the
motor and panel leads as shown
in (fig. 22)
Step B4.
Bundle and re-attach the wires to
the rodent screen with zip ties.
fig. 21
fig. 22
A. For the 9910APV:
Step A1.
Connect the leads of the first solar panel to the Y-Adapter
as shown in (fig. 15 & 16) Make sure to connect black to
black and red to red, etc.
B. For the 9910TRP:
Step B1.
An access point is located under the shroud to allow for
connecting an extra panel. (fig. 19)
Cut the zip ties that hold the wires to the frame. (fig. 20)
Step A3.
Connect the other end of the Y-Adapter (fig. 17) to the
motor make sure to connect the black lead to the black
post and red lead to the red post. (fig. 18)
fig. 20