Universal Air Tools UT8606 - Manual

Read these instructions carefully before installing, operating,
servicing or repairing this tool. Keep these instructions in a safe
accessible place.
Important Operator Instructions
Includes - Foreseen Use, Work Stations, Putting Into Service, Operating, Tool
Maintenance and Safety Rules
Manufacturer/Supplier Product Type RPM
Cycles Per Min Universal Air Tool Company Limited
Unit 8
Lane End Industrial Park
High Wycombe
Bucks
HP14 3BY
Tel No Fax No (01494) 883300 (01494) 883237
Model No/Nos Serial No
Product Nett Weight
lbs
Kg
Recommended Use Of
Balancer Or Support
Recommended Hose Bore
Size - Minimum
Recommended Max.
Hose Length
Ins M/M Ft M
Foreseen Use of the Tool
The tool is designed to cut sheet metal by a shear action using a
moving blade and two fixed blades. It will cut metal sheet of thickness
1.2 mm in steel and 1.6mm in aluminium. The tool cuts the sheet
by removal of a strip of metal the width of the moving blade. It is
possible to cut various types of sheet in other materials i.e. plastic and
fibre board either in flat or corrugated form.
Do not use the tool for any other purpose than that for which it is
designed and never modify the tool for any other use.
Putting Into Service
Air Supply
Use a clean lubricated air supply that will give a measured air pressure
at the tool of 90 p.s.i./6.3 bar when the tool is running with the trigger
fully depressed. Use recommended hose size and length. It is
recommended that the tool is connected to the air supply as shown
in figure 1. Do not connect the tool to the air line system without
incorporating an easy to reach and operate air shut off valve. The air
supply should be lubricated. It is strongly recommended that an air
filter, regulator, lubricator (FRL) is used as shown in Figure 1 as this
will supply clean, lubricated air at the correct pressure to the tool.
Details of such equipment can be obtained from your supplier. If such
Work Stations
The tool should only be
used as a handheld,
hand operated tool. It is
always recommended
that the tool is used
when standing on a solid
floor. It can be used in
other positions but be-
fore any such use, the
operator must be in a
secure position having a
firm grip and footing and
be aware of a reaction
force on the hand as
result of the tool doing
work.
Pistol Shear
UT8606
2,600
3/8 10 30 10 No
2.2
1.0
Page No 1
Noise Level Sound Pressure Level 91.0 dB(A)
Test Method Tested in accordance with
BS EN ISO 15744:2008
Vibration Level
Test Method Tested in accordance with
BS EN ISO 28927-7:2009
Less than 2.5 Metres / Sec²
Air Pressure
Recommended Working 6.3 bar 90 PSI
Recommended Minimum n/a bar n/a PSI
Maximum 7.0 bar 100 PSI
1301000 - 2312000
Personal Safety Equipment
Use - Safety Glasses Yes
Use - Safety Gloves
Use - Safety Boots
Use - Breathing Masks
Use - Ear Protectors Yes