Universal Air Tools UT5715 - Manual

Manufacturer/Supplier Product Type
RPM
Cycles Per Min
Tel No Fax No
Model No/Nos Serial No
Product Nett Weight
lbs
Kg
Recommended Use Of
Balancer Or Support
Recommended Hose Bore
Size - Minimum
Recommended Max.
Hose Length
Ins M/M Ft M
Foreseen Use Of The Tool
This die grinder is primarily designed for use with bonded
abrasive mounted point grinding wheels. It may also be used
with steel rotary files and carbide burrs provided their speed
rating matches the speed of the grinder.
This tool should not be fitted with cutting off wheels, saw
blades, drill bits, etc. If there is any doubt about the correct use
of this product contact your supplier for advice.
Also make sure that the shank size of the attachment to be
driven matches with the collet size fitted in the grinder and that
the maximum allowed running speed of the attachment exceeds
that marked on the grinder.
There are special rules governing the use of bonded abrasive
mounted point grinding wheels - for details see section
"Operating".
Putting Into Service
Air Supply
Use a clean lubricated air supply that will give a measured air
pressure at the tool of 90 p.s.i./6.3 bar when the tool is running
with the lever/trigger fully depressed. Use recommended hose
size and length. It is recommended that the tool is connected to
the air supply as shown in figure 1. Do not connect the tool to
the air line system without incorporating an easy to reach and
operate air shut off valve. The air supply should be lubricated. It
is strongly recommended that an air filter, regulator, lubricator
(FRL) is used as shown in Figure 1 as this will supply clean,
lubricated air at the correct pressure to the tool. Details of such
equipment can be obtained from your supplier. If such
equipment is not used then the tool should be lubricated by
shutting off the air supply to the tool, depressurising the line by
pressing the lever/trigger on the tool. Disconnect the air line and
Work Stations
The tool should only be used as
a handheld hand operated tool.
It is always recommended that
the tool is used when standing
on the solid floor. It can be
used in other positions but
before any such use, the
operator must be in a secure
position having a firm grip and
footing and be aware of the
extra safety precautions that
must be observed when using
Grinding Machines.
No
Page No 1
Die Grinder - Right
Angle Head
UT5715
1.10
0.50 3/8 10 30 10
22,000
Includes - Foreseen Use, Work Stations, Putting Into Service,
Operating, Dismantling, Assembly and Safety Rules
Operator Instructions Important
Read these instructions carefully before installing, operating,
servicing or repairing this tool. Keep these instructions in a safe
accessible place.
Noise Level
Sound Pressure Level 90.0 dB(A)
Test Method
Tested in accordance with Pneurop
test code PN8NTC1 and ISO Standard 3744
Sound Power Level 97.0 dB(A)
Vibration Level
Test Method
Tested in accordance with ISO
standard 8662 Parts 1 & 17
Less than 2.5
Metres / Sec²
Universal Air Tool Company Limited
Unit 8
Lane End Industrial Park
High Wycombe
Bucks
HP14 3BY
(01494) 883300 (01494) 883237
Air Pressure
Recommended Working
6.3
bar
90
PSI
Recommended Minimum
n/a
bar
n/a
PSI
Maximum
7
bar
100
PSI
Personal Safety Equipment
Use - Safety Glasses Yes
Use - Safety Gloves Yes
Use - Safety Boots
Use - Breathing Masks
Yes
Use - Ear Protectors Yes