USGlobalsat EB-5662RE - Manual (Page 20)

EB-5662RE
High Performance GPS Engine Board
- 20 -
command to allow the receiver to correctly decode the data. When a valid message is received,
the parameters will be stored in battery backed SRAM and then the receiver will restart using the
saved parameters.
Format:
＄PSRF102,<Baud>,<DataBits>,<StopBits>,<Parity>*CKSUM<CR><LF>
<baud> 1200,2400,4800,9600,19200,38400
<DataBits> 8
<StopBits> 0,1
<Parity> 0=None, Odd=1,Even=2
Example: Set DGPS Port to be 9600,8,N,1
＄PSRF102,9600,8,1.0*12
D). Query/Rate Control ID: 103 Query standard NMEA message and/or set output rate
This command is used to control the output of standard NMEA message GGA, GLL, GSA, GSV,
RMC, VTG. Using this command message, standard NMEA message may be polled once, or
setup for periodic output. Checksums may also be enabled or disabled depending on the needs of
the receiving program. NMEA message settings are saved in battery backed memory for each
entry when the message is accepted.
Format:
＄PSRF103,<msg>,<mode>,<rate>,<cksumEnable>*CKSUM<CR><LF>
<msg> 0=GGA,
1=GLL,
2=GSA,
3=GSV,
4=RMC,
5=VTG
6=MSS(if internal beacon is supported)
7=Not defined
8=ZDA(if 1PPS output supported)
9=Not defined
<mode> 0=SetRate
1=Query
2=ABP On