USGlobalsat ET-314 - Manual (Page 16)

ET-314
The Specifications are subject to be changed without notice. Copyright © 2007, GlobalSat Technology.
Page 16 of 19
Version 1.2
value if available. If this is unavailable, a default
value of 75000 for GSP1, 95000 for GSP 1/LX will be used.
INT32
<TimeOf Week> GPS Time Of Week
UINT32
<WeekNo> GPS Week Number
UINT16
（ Week No and Time Of Week calculation from UTC time）
<chnlCount> Number of channels to use.1-12. If your CPU throughput
is not high enough, you could decrease needed
throughput by reducing the number of active channels
UBYTE
<ResetCfg> bit mask
0 ×01=Data Valid warm/hotstarts=1
0 ×02=clear ephemeris warm start=1
0 ×04=clear memory. Cold start=1
UBYTE
Example: Start using known position and time.
＄PSRF101,-2686700,-4304200,3851624,96000,497260,921,12,3*7F
C). Set DGPS Port ID:102 Set PORT B parameters for DGPS input
This command is used to control Serial Port B that is an input only serial port
used to receive
RTCM differential corrections.
Differential receivers may output corrections using different
communication parameters. The default
communication parameters for PORT B are 9600
Baud, 8data bits, 0 stop bits, and no parity. If a DGPS
receiver is used which has different communication parameters, use this command to allow
the receiver to correctly decode the data. When a valid message is received, the
parameters will be stored in battery backed SRAM and then the receiver will restart using
the saved parameters.
Format:
＄PSRF102,<Baud>,<DataBits>,<StopBits>,<Parity>*CKSUM<CR><LF>
<baud> 1200,2400,4800,9600,19200,38400
<DataBits> 8
<StopBits> 0,1