WEN 3710 10 inch Table Saw ver.2011 - Manual (Page 23)

23
Bevel Crosscutting (Figure 23)
BEVEL CROSSCUTTING is the same as crosscutting
except that the wood is also cut at an angle … other than
90° with the flat side of the wood (Figure 23).
Adjust the blade to the desired angle and lock it.
Use the Miter Gauge in the groove to the RIGHT of the
blade. It cannot be used in the groove to the LEFT
because the blade guard will interfere.
Hold the workpiece with your right hand and the lock
knob with your left hand.
Compound Miter Cutting
COMPOUND MITER CUTTING is a combination of miter cutting and bevel crosscutting. The cut is
made at an angle other than 90° to both the edge and the flat side of the wood.
Adjust the miter gauge and the blade to the desired angle. Make sure miter gauge is locked.