WEN 70716 10 inch Sliding Compound Miter Saw - Manual (Page 9)

Bevel lock
The bevel lock (11) is used to set the blade at the desired bevel angle (Fig. 5). The miter saw bevels from 0° to 45°
left.
WARNING: Be sure to tighten the bevel lock before making a cut. Failure to do so could result in the
saw arm moving during the cut and cause serious personal injury.
Hold down clamp assembly
The hold down clamp assembly can be mounted to the fence on either side of the saw
bladedepending onwhat suits the task at hand.Use the clamp assembly lock at the back of the
fence to secure the clamp assembly in position (Fig. 6).
Note: use only ONE clamp at a time.
pindle lock button
n prevents the blade in the saw from rotating (Fig. 7). Depress and hold the
otating lower blade guard
provides protection from both sides of the blade (Fig. 8).
ust collection bag
g fits over the dust extraction port (14). For more efficient operation,
ttaching the material support arms
rt the materialwhen working
ing screws must be tightenedto secure the
Fig. 6
Fig. 7
S
The spindle lock butto
spindle lock button while installing, changing or removing the blade.
R
The rotating lower blade guard
It retracts over the upper blade guard as the saw is lowered onto the workpiece.
Fig. 8
D
The dust collection ba
empty the dust bag when it is half full. This allows better air flow through the bag.
A
Fig. 9 Fig. 10
The material support arms help to suppo
with longworkpieces. There are two location holes for asupport bar on
either side ofthe table. Loosen the lock screws with the 6mmhex key.
Ensure the sidebarsare fully inserted before usingthem to support the
workpiece(Fig. 9 & 10).
The side support bar lock
support bars inposition (Fig. 9 & 10).
9