General safety rules (continued) – WEN 4210 10 inch Drill Press with Cross Hair Laser ver.2014 User Manual

Page 4

Advertising
background image

4

General safety rules (continued)


13. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to OFF. Do

not leave the tool until it has come to a complete stop.


14. NEVER STAND ON A TOOL. Serious injury could result if the tool tips or is accidentally hit.
DO NOT store anything above or near the tool.

15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant

rubber-soled footwear. Keep the floor clear of oil, scrap, and other debris.


16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order.

Follow instructions for lubricating and changing accessories.


17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, breakage,

improper mounting, or any other conditions that may affect the tool’s operation. Any part that is
damaged should be properly repaired or replaced before use.


18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches and ALWAYS

remove starter keys.


19. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that

could affect your ability to use the tool properly.


20. USE SAFETY GOGGLES AT ALL TIMES—that comply with

ANSI Z87.1. Normal safety glasses only have impact resistant lenses
and are not designed for safety. Wear a face or dust mask when
working in a dusty environment. Use ear protection, such as plugs or
muffs, during extended periods of operation.


Laser safety


1. Do not stare directly at the laser beam. Eye damage may occur if

you deliberately stare into the beam.

2. The laser light beam used in this system is Class II with maximum

1 mW and 660 nm wavelengths. AVOID DIRECT EYE
EXPOSURE.

3. The laser must be used and maintained in accordance with the

manufacturer’s instructions:

Never aim the beam at any person or an object other than

the workpiece.

Do not project the laser beam into the eyes of others.

Always ensure the laser beam is aimed at a workpiece

without reflective surfaces as the laser beam could be
projected into your eyes or the eyes of others.

Advertising