WEN 56660 9 AMP Snow Shovel Handle Assembly - Manual

STEP 1 (Fig.1)
Remove the two bolts located on the snow shovel’s base and set aside for step 7
STEP 2 (Fig.2)
Loosen the lower red knob and pull out the Inner pole handle pipe, by inserting a screw-
driver in the hole located on the end and pulling it out of the outer handle pipe, then tighten
the lower knob to keep the inner pole from sliding back in.
STEP 3
Insert upper pipe into the units plastic handle by aligning the notch on one side (Fig.3A)
and snapping the tab into the hole located on the opposite side of the pole (Fig.3B) .
STEP 4
Secure the handle to the upper pipe by sliding the handle fastner knob
up to the threads and turning clockwise to tighten
(Fig.4A & 4B) .
STEP 5
Insert small plastic notch track onto the lower handle pipe, aligning the
notch
(Fig.5A) , and matching the holes (Fig.5B) .
STEP 6 (Fig.6A & 6B)
Insert the electric cord followed by the handle into the base making
sure it is facing the correct direction and the notches are matching.
STEP 7 (Fig.7)
Insert and secure the bolts that were removed in step 1.
Snow Shovel Handle Assembly Instructions
Fig. 1
Fig. 2
Fig. 3B
Fig. 4B
Fig. 5B
Fig. 3A
Fig. 4A
Fig. 5A
Fig. 7
Fig. 6A Fig. 6B
Lower Knob
Align Notch
Align Holes
Align Notch
Electric Cord
Align Notch
Slide
Down
Pull Out
Notch
Align & Snap Tab
into Hole
STEP 8
Loosen the upper red knob and handle bolt,
then adjust the lower handle for comfort and
re-tighten.
Model 56660