WEN 49036 3.6V Lithium Ion Cordless Screwdriver - Manual (Page 7)

OPERATION
CHARGING THE BATTERY
WARNING: The charger and battery pack are specifically designed to work together so do not attempt to use any
other devices. Never insert or allow metallic objects into your charger or battery pack connections because an
electrical failure and hazard will occur.
Your battery pack is UNCHARGED and you must charge once before use. The charger is designed to use standard
household 120volt 60Hz power.
1. Insert the charger jack into the charger port.
2. Plug the charger into any standard 120 Volt 60 Hz electrical outlet and let the tool charge 3-5 hours.
NOTE: Do not charge by means of an engine generator or DC power source. Use only 120V AC.
3. Disconnect the charger from the outlet, then disconnect the charger from the tool.
CAUTION: Do not use the tool while it is connected to the charger.
TRIGGER SWITCH & REVERSING BUTTON
The screwdriver is turned ON and OFF by pulling and releasing the trigger switch.
A forward/reverse control button determines the direction of the tool and also serves as a lock off button.
To select forward rotation, release the trigger switch and depress the forward/reverse control button to the left.
To select reverse, depress the forward/reverse control button the opposite direction.
NOTE: The center position of the control button locks the tool in the off position. When changing the position of
the control button, be sure the trigger is released.
LED WORKLIGHT
The LED worklight, located on the front of the Drill/Driver, will illuminate when the LED worklight switch is
turned on. This provides additional light on the surface of the workpiece for operation in lower-light areas.
The LED worklight will turn off when the LED worklight is turned off.
FITTING SCREWDRIVER BITS
Insert a 1/4” bit into the screwdriver collet.
Note: Your drill is intended for light-duty use. For best results, 1⁄4” screwdriver bits are recommended.
Never engage the trigger switch when changing screwdriver bits.
Always lock the trigger switch when changing drill bits. (See Trigger switch & reversing button section.)
7