Work Sharp Sharpening System - Manual (Page 19)

The photo right shows how the grit on
the second side will obscure the num-
bers so marking the grit number on the
face will be a handy reference.
The photo below shows the MicroMesh
6000 rolling onto the back side of the
leather strop plate. You can either start
from the center and roll it out both direc-
tions, or start at one side with the center
hole aligned and roll all in the same di-
rection.
The bottom photo shows the four glass
plate set up I use: the two plates that
come with the Work Sharp plus one ex-
tra glass plate plus the leather strop
plate. With this set up the grit steps are
P80, P120, P220, P400, P1000, Mi-
croMesh 3600, MicroMesh 6000 and the
leather strop with buffing compound (in-
cluded with the strop plate).
Now we are ready to tackle that ugly old
chisel.