WycoTool WBP50 Backpack - Manual (Page 11)

User Manual
Page 11 March 2014
◊ Carbon monoxide poisoning from engine exhaust.
Operate outside away from open windows or doors .
◊ Burns from hot parts.
Let the engine and exhaust system cool
before touching .
◊ Injury from moving parts.
Do not run the engine unless instructed to do so .
• Read the instructions before you begin, and make sure
you have the tools and skills required .
• To reduce the possibility of fire or explosion, be careful
when working around gasoline . Use only a non-
flammable solvent, not gasoline, to clean parts . Keep
cigarettes, sparks and flames away from all
fuel-related parts .
Remember that an authorized Honda servicing dealer knows
your engine best and is fully equipped to maintain and
repair it .
To ensure the best quality and reliability, use only new
genuine Honda parts or their equivalents for repair
and replacement .
Maintenance Schedule
Regular Service Period (1)
Perform at every indicated
month or operating hour
interval, whichever comes first .
Each
use
First
month
or 10 hr
Every 3
months
or 25 hr
Every 6
months
or 50 hr
Every
year
or 100
hr
Every
2
years
or 300
hr
Engine oil
Check
level
X
Change X (3)
Air filter
Check X
Clean X (2)
Spark plug
Check,
adjust
X
Replace X
Spark arrester
(applicable types)
Clean X
Fuel tank and filter Clean X (4)
* Idle speed
Check,
adjust
* Valve clearance
Check,
adjust
X (4)
*Combustion
chamber
Clean X (4)
* Fuel tube Check
* See the Honda Owner’s Manual .
(1) For commercial use, log hours of operation to determine
proper maintenance intervals .
(2) Service more frequently when used in dusty areas .
(3) Change engine oil every 25 hours when used under heavy
load or in high ambient temperatures .
(4) These items should be serviced by your Honda
servicing dealer, unless you have the proper tools and are
mechanically proficient . See the Honda Owner’s Manual for
service procedures .
Failure to follow this maintenance schedule could result in
non- warrantable failures .
Refueling
Recommended Fuel
Unleaded gasoline
U .S . Pump octane rating 86 or higher
Except
U .S .
Research octane rating 91 or higher
Pump octane rating 86 or higher
This engine is certified to operate on unleaded gasoline with
a pump octane rating of 86 or higher (a research octane
rating of 91 or higher) .
Refuel in a well-ventilated area with the engine stopped .
If the engine has been running, allow it to cool first . Never
refuel the engine inside a building where gasoline fumes
may reach flames or sparks .
You may use regular unleaded gasoline containing no
more than 10% Ethanol (E10) or 5% Methanol by volume .
In addition, Methanol must contain co-solvents and
corrosion inhibitors . Use of fuels with content of Ethanol
or Methanol greater than shown above may cause starting
and/or performance problems . It may also damage metal,
rubber, and plastic parts of the fuel system . Engine damage
or performance problems that result from using a fuel with
percentages of Ethanol or Methanol greater than shown
above are not covered under the warranty .
GASOLINE IS HIGHLY FLAMMABLE AND EXPLOSIVE, AND
YOU CAN BE BURNED OR SERIOUSLY INJURED WHEN
REFUELING.
• STOP ENGINE AND KEEP HEAT, SPARKS, AND FLAME
AWAY.
• REFUEL ONLY OUTDOORS.
• WIPE UP SPILLS IMMEDIATELY.
OTEE: N Fuel can damage paint and some types of plastic . Be
careful not to spill fuel when filling your fuel tank .
Damage caused by spilled fuel is not covered under
the Distributor’s Limited Warranty . Move at least 1
meter (39 inches) away from the fueling source and
site before starting the engine .
1 . With the engine stopped and on a level surface, remove
the fuel filler cap and check the fuel level . Refill the tank if
the fuel level is low .
2 . Add fuel to the bottom of the fuel level mark of the fuel
tank . Do not overfill . Wipe up spilled fuel before starting
the engine .