WycoTool Hydraulic Paving Vibrators - Manual (Page 20)

18
18
Wyco Tool Company
Install the protective hose (27) completely
onto the hose barb of the angle bracket.
Position the Punch Lock Clamp (26) over the
protective hose about ¼ inch apart over the
hose barb section.
Tighten and lock the clamp according to the
manufacturer’s instructions.
Install the rubber plug (30) around the
hydraulic hoses at the opposite end of the
protective hose and tap in until it is flush with
the end.
Install one hose clamp (29) directly over the
rubber plug at the end of protective hose
(27) and tighten. Reuse the nameplate (28)
with the remaining hose clamp. Impression
stamp the service date on the nameplate for
future reference.
If bearings have been replaced, replace the
square housing assembly. Return to Section
c6 for assembly instructions. If bearings have
not been replaced go to Section c2.
g) Speed Sensing/Smart Vibrators
When Wyco Tool supplies vibrators that have
the speed sensing option, a cable exits the
back of the hydraulic motor next to the
hydraulic hoses. This armored and shielded
cable (Wyco # 420-005) extends 9 feet away
from the hydraulic motor. It runs parallel to
the hydraulic hose and inside the protective
hose. When the protective hose is greater than
8 feet, an extension cable will be needed to
exit the rubber plug.