Avaya 5620 - Manual (Page 28)

5620user
4620/5620 Phone User Guide Page 28
IP Office Issue 2d (15th September 2005)
Longhand Programming Mode
1. Press Admin or Admin 1. See Display Key Programming. .
2. Pressing Expl? to switch to longhand programming mode.
3. Press Next until the required function required is shown, then press Selct .
4. If the function requires some data to be entered, [ is shown at the bottom of the display. Enter the
data using the normal telephone keypad.
5. The upper part of the display reverts to showing the functions currently assigned to each and
key.
6. Use the and keys to move between the pages of display keys.
7. Select the display key against which to program the new function by pressing that or key.
• Caution: Do not select the slot used for the Admin function. Replacing this function will
lock the phone for further programming until reset through the telephone system.
8. If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
• Press EXIT to end programming.
• Press Cont to continue programming other functions.
9. If the display slot already has a programmed function, the display shows FEATURE ON
BUTTON. Press the and keys until Repla, Keep and Delet are shown along the right-hand
edge of the display.
• Press Repla to replace that existing function with the one just programmed. The
display then shows BUTTON PROGRAMMED! as above.
• Press Keep to keep the existing function and forget the function just programmed.
• Press Delete to delete the existing function and forget the function just programmed.