Avigilon AMAG Symmetry 7 Integration - Manual (Page 12)

Avigilon Control Center 5 System Integration Guide with AMAG SMS
8
application that is used to configure the connection and alarm mappings between the
AMAG and the Avigilon systems.
Configuring Server Settings
Configure the Alarm Mapping Gateway to access the two applications.
The configuration application remembers the server configuration, so you do not need to
repeat this procedure if the settings remain the same.
After you install the integration software, the Configuration Tool automatically opens. To
access it manually, select All Programs > Avigilon > Avigilon AMAG SMS Gateway >
Configure Avigilon to AMAG SMS Gateway.
• If you upgraded your integration and all the configurations were successfully
imported, you will automatically see the Configuration Tool window. Click
Configure Connections.
• If this is a new installation, you will automatically see the Configure
Connections dialog box. Click Add.
a.
In the following dialog box, enter the Avigilon Server IP Address, User
Name and Password, then click OK.
Use the username and password you created for the integration. See Adding
an Integration User in Avigilon on page 4.
NOTE: If the Avigilon Control Center Server and the Avigilon AMAG Gateway Integration
are installed on the same server, set the server IP Address as 127.0.0.1 instead
of the actual IP address.