Catskill Craftsmen 51536 - Manual (Page 8)

1 1/2” Long 3/16” DIA. Steel Pin
4 used in
this step
5/8” Phillips Flat Head #8 Screw
3 used in this step
Magnet Plate
7/8” Truss Head Machine Screw
2 used
in this step
1/2” Phillips Flat Head #4 Screw
1 used in this step
STEP 7
Place a washer on the 1” #8 screws and attach handle/
towel bar to side panel from inside the side panel.
2 used in this step
1” Phillips Flat Head #8 Screw
2 used
in this step
3/16” Flat Washer
STEP 8
A. Tap/insert ONE 1 1/2” pin into
each end of both doors. DON’T
OVERDRIVE PINS! Pins should
stick up about 1/2” when seated.
B. Attach the door spacer to the
left door with 5/8” #8 screws.
The spacer has a space at the
top to allow magnet clearance
and is almost flush with the
bottom of the door. Countersunk
holes out.
C. Attach the magnet plate
(may be stuck to magnet!)
with the 1/2” #4 screw to the
top of the right door. Bumps go
toward the wood.
D. Attach door handles with
7/8” truss head machine screws.
No illustration.
ILLUSTRATION 7
ILLUSTRATION 8
Right Door
Inside View
Left Door
Inside View