Edwards Signaling 125 Class Standard LED - Manual (Page 2)

Table 1. Replacement Parts
GRAY BASE BLACK BASE
Catalog Number Catalog Number
Replacement
Lens Replacement Lamp
Flashing LED
125LEDF*24D 125LEDF*24DB
125L*
The 100,000 hour** LED light
source is permanently installed. 125LEDF*120A 125LEDF*120AB
Steady-On LED
125LEDS*24D 125LEDS*24DB
125L*
The 100,000 hour** LED light
source is permanently installed.
125LEDS*120A 125LEDS*120AB
*Letter in this position indicates lens color: A - Amber, B - Blue, G - Green, R - Red
**Based on LED manufacturer's projections.
Figure 2. Panel Mounting
125 Class
Visual Indicator
Gasket
(supplied)
Locking Nut -
1.3625" OD
(supplied)
Control panel
(enclosure)
Wire Nuts
(Not Supplied)
18” Wire Leads
Power Source
Wires
Figure 1. Conduit Mounting (3/4" Shown)
125 Class
Visual Indicator
Power Source
Wires
DC units; Red positive (+)
AC units; Black Hot
DC units; Black negative (-)
AC units; White neutral
Wire nuts
(not supplied)
18” Wire Leads
3/4” NPT external (shown)
1/2” NPT internal
conduit (not supplied)
Maintenance Cleaning
Disconnect power before cleaning. The module lens exterior
surfaces should be periodically cleaned with a soft clean cloth
using water and a mild detergent to maintain optimum light
visibility. To avoid risk of injury, install lens before
energizing the unit.
To avoid the risk of injury, do not start any
maintenance when unit is energized.
WARNINGS