Edwards Signaling E-RLY - Manual (Page 4)

4 / 4 P/N 3101196 • REV 02 • ISS 28JAN13
Specifications
Communication line voltage Maximum 20.6 V peak-to-peak
Current
Standby
Activated
125 µA
125 µA
Contact ratings (pilot duty)
30 VDC
125 VAC
2 A
0.5 A resistive load 60 W or 62.5 VA
max.
Relay type Form C, programmable
Ground fault impedance
10 kΩ
Compatible electrical boxes 4 inch square, 2-1/2 in. (64 mm)
deep single-gang box
4 inch square, 2-1/2 in. (64 mm)
deep double-gang box
Standard 4 in. square,
1-1/2 in. (38 mm) deep box
Wire size 12, 14, 16, or 18 AWG wire (2.5,
1.5, 1.0, or 0.75 mm
2 ) (Sizes 16
and 18 AWG are preferred)
Operating environment
Temperature
Relative humidity
32 to 120°F (0 to 49°C)
0 to 93%, noncondensing
Storage temperature range –4 to 140°F (–20 to 60°C)
Module address 01 to 64 (64 point control panel)
01 to 127 (127 point control panel)
Regulatory information
Manufacturer Edwards, A Division of UTC Fire & Security
Americas Corporation, Inc.
8985 Town Center Parkway, Bradenton, FL
34202, USA
Year of
manufacture The first two digits of the DATE MFG number
(located on the product identification label) are
the year of manufacture.
North American
standards CAN/ULC-S527, UL 864
FCC compliance This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
Contact information
For contact information, see www.edwardssignaling.com.