Edwards Signaling 117 Series - Manual

© 2013 UTC Fire & Security. All rights reserved. 1 / 2 P/N 3100818 • REV 02 • REB 25FEB13
117 Series Strobe Installation Sheet
Description
The Edwards 117 Series Strobe is a low profile, surface
mounted UL and cUL listed signaling appliances in a NEMA 4X
rated enclosure.
Installation
WARNING: To prevent electrical shock, ensure power is
turned off before installation or maintenance.
To surface mount the strobe:
1. Place the mounting gasket (supplied) over the hole in the
surface and route the signal wires through the gasket and
the hole in the panel.
2. Secure the beacon to the surface using two screws
appropriate for the mounting surface (not supplied).
3. Using wire nuts (not supplied), connect the signal's wire
leads as shown in Figure 1. Polarity must be observed on
DC units.
Specifications
Catalog no. Voltage Current Replacement
strobe tube
117*-EM 10-110 VDC 0.35A 114-ST
117*-N5 120 VAC 0.02A 91B-ST
117*-R5 240 VAC 0.015A 91B-ST
* Letter in this position indicates lens color: A - amber, B - blue, C -
clear, G - green, or R - red
Maintenance
Cleaning
The module lens exterior surfaces should be periodically
cleaned with a soft clean cloth using water and a mild
detergent to maintain optimum light visibility. Disconnect power
before cleaning.
Light source replacement
1. Disconnect wiring.
2. Unscrew lens from base.
3. Unplug strobe tube and replace with new strobe tube as
appropriate (see specifications). Replace lens on base.
Figure 1: Mounting