What to do if there is a fire in your home, What this smoke alarm can do, Placement of smoke alarms – Edwards Signaling 517TC User Manual

Page 2

Advertising
background image

· Keep electrical appliances and cords in good working order and do

not overload electrical circuits.

· Keep stoves, fireplaces, chimneys, and barbecue grills grease-free and

make sure they are properly installed away from combustible materials.

· Keep portable heaters and open flames such as candles away from com-

bustible materials.

· Do not allow rubbish to accumulate.

c. Develop a family escape plan and practice it with your entire fam-

ily, especially small children.

· Draw a floor plan of your home and find two ways to exit from each

room. There should be one way to get out of each bedroom without

opening the door.

· Teach children what the smoke alarm signal means, and that they

must be prepared to leave the residence by themselves if necessary.

Show them how to check to see if doors are hot before opening them,

how to stay close to the floor and crawl if necessary, and how to use

the alternate exit if the door is hot and should not be opened.

· Decide on a meeting place a safe distance from your house and make

sure that all your children understand that they should go and wait for

you if there is a fire.

· Hold fire drills at least every 6 months to make sure that everyone,

even small children, know what to do to escape safely.

· Know where to go to call the fire department from outside your resi-

dence.

· Provide emergency equipment such as fire extinguishers and teach

your family to use this equipment properly.

WHAT TO DO IF THERE IS A FIRE

IN YOUR HOME

If you have prepared family escape plans and practiced them with your

family, you have increased their chances of escaping safely. Review the

following rules with your children when you have fire drills so everyone will

remember them in a real fire emergency:

a. Don’t panic; stay calm. Your safe escape may depend on thinking

clearly and remembering what you have practiced.

b. Get out of the house following a planned escape route as quickly as

possible. Do not stop to collect anything or to get dressed.

c. Open doors carefully only after feeling to see if they are hot. Do not

open a door if it is hot; use an alternate escape route.

d. Stay close to the floor; smoke and hot gases rise.

e. Cover your nose and mouth with a cloth, wet if possible, and take short,

shallow breaths.

f. Keep doors and windows closed unless you open them to escape.

g. Meet at your prearranged meeting place after leaving the house.

h. Call the Fire Department as soon as possible from outside your house.

Give the address and your name.

i. Never re-enter a burning building.

Contact your local Fire Department for more information on making your
home safer from fires and about preparing your family’s escape plans.

WHAT THIS SMOKE ALARM CAN DO

This alarm is designed to sense smoke entering its sensing chamber. It

does not sense gas, heat (except 517TH), or flames.

When properly located, installed, and maintained, this smoke alarm is

designed to provide early warning of developing fires at a reasonable cost.

This alarm monitors the air and, when it senses smoke, activates its built-

in alarm horn. It can provide precious time for you and your family to

escape from your residence before a fire spreads. Such an early warning,

however, is possible only if the alarm is located, installed, and maintained

as specified in this User’s Manual.

NOTE: This smoke alarm is designed for use within single residential

living units only; that is, it should be used inside a single-family home or

one apartment of a multi-family building. In a multi-family building, the

alarm may not provide early warning for residents if it is placed outside of

the residential units, such as on outside porches, in corridors, lobbies, base-

ments, or in other apartments. In multi-family buildings, each residential

unit should have alarms to alert the residents of that unit. Alarms designed

to be interconnected should be interconnected within one family residence

only; otherwise, nuisance alarms will occur when an alarm in another living
unit is tested.

IMPORTANT NOTE: WHAT SMOKE ALARMS
CANNOT DO

Smoke alarms will not work without power. Battery-operated

alarms will not work without batteries, with dead batteries, or if the batter-

ies are not installed properly. AC powered alarms will not work if their AC

power supply is cut off by an electrical fire, an open fuse or circuit

breaker, or for any other reason. If you are concerned about the reliability

of either the batteries or your AC power supply for any of the above

reasons, you should install both battery and AC powered alarms for

maximum safety.

Smoke alarms may not sense fire that starts where smoke

cannot reach the alarms such as in chimneys, in walls, on roofs, or on

the other side of closed doors. If bedroom doors are usually closed at

night, alarms should be placed in each bedroom as well as in the common

hallway between them.

Smoke alarms also may not sense a fire on another level of a

residence or building. For example, a second-floor alarm may not

sense a first-floor or basement fire. Therefore, alarms should be

placed on every level of a residence or building.

The horn in your alarm meets or exceeds current audibility require-

ments of Underwriters Laboratories. However, if the alarm is located

outside a bedroom, it may not wake up a sound sleeper, espe-

cially if the bedroom door is closed or only partly open. If the alarm is

located on a different level of the residence than the bedroom, it is even

less likely to wake up people sleeping in the bedroom. In such cases, the

National Fire Protection Association recommends that the alarms be inter-

connected so that an alarm on any level of the residence will sound an

alarm loud enough to awaken sleepers in closed bedrooms. This can be

done by installing a fire-detection system, by connecting alarms together,

or by using radio frequency transmitters and receivers.

All types of smoke alarm sensors have limitations. No type of

smoke alarm can sense every kind of fire every time. In gen-

eral, alarms may not always warn you about fires caused by

carelessness and safety hazards like smoking in bed, violent

explosions, over-loaded electrical circuits, children playing with

matches, escaping gas, improper storage of flammable materi-

als, or arson.

NOTE: This alarm is not designed to replace special-purpose fire de-

tection and alarm systems necessary to protect persons and property in

non-residential buildings such as warehouses, or other large industrial or

commercial buildings. It alone is not a suitable substitute for complete

fire-detection systems designed to protect individuals in hotels and mo-

tels, dormitories, hospitals, or other health and supervisory care and

retirement homes. Please refer to NFPA 101,The Life Safety Code, and

NFPA 72 for smoke alarm requirements for fire protection in buildings not

defined as “households.”

Installing smoke alarms may make you eligible for lower insurance rates,

but smoke alarms are not a substitute for insurance. Home owners

and renters should continue to insure their lives and property.

PLACEMENT OF SMOKE ALARMS

THIS EQUIPMENT SHOULD BE INSTALLED IN ACCORDANCE WITH

THE NATIONAL FIRE PROTECTION ASSOCIATION’S STANDARD 72

(National Fire Protection Association, Batterymarch Park, Quincy, MA

02269).

For your information, the National Fire Protection Association’s Stan-

dard 72, reads as follows:

“Smoke detectors shall be installed outside of each separate sleeping area

in the immediate vicinity of the bedrooms and on each additional story of the

family living unit including basements and excluding crawl spaces and unfin-

ished attics. In new construction, a smoke detector shall be installed in each

sleeping room.”

Where to Locate the Required Smoke Detectors in Existing Construction.

The major threat from fire in a family living unit is at night when everyone is

asleep. The principal threat to persons in sleeping areas comes from fires in

the remainder of the unit; therefore, a smoke alarm(s) is best located between

the bedroom areas and the rest of the unit. In units with only one bedroom

area on one floor, the smoke alarms should be located as shown in

Figure 1.

Advertising
This manual is related to the following products: