Edwards Signaling 517FH - Manual (Page 6)

MOUNTING: PLATE & ALARM
1. Lace the connector through the provided mounting plate and
secure the plate to the junction box.
2. Plug the wire connector into the alarm base.
3. Place the alarm up to the mounting plate, rotating it clockwise
until alarm firmly snap locks into place. Keep the alarm paral-
lel to the mounting plate so upper and lower tabs on the plate
seat correctly into the alarm.
TESTING
Use a hair dryer and direct hot air towards the silver disk on the
face of the detector or use a portable soldering iron and place it
against the heat sensor. Testing should be conducted semian-
nually.
WARNING: Never use an open flame of any kind to test your
detector. You may ignite and damage the detector as well as
your home
LIMITED WARRANTY
Providing Purchaser or Distributor notifies us promptly if within two (2) years from date of
shipment from Edwards Company, equipment or parts manufactured by us fail to function
properly under normal use because of defects in material or workmanship demonstrated
to our satisfaction to have existed at the time of delivery or because examination proves
them not to be operating within the specified limit of calibration, the Company, reserving
the right to either inspect them in your hands or request their return to us, will at our
option repair or repace at our expense F.O.B. shipping point, such equipment or parts
determined by us to be defective, if returned transportation prepaid by Purchaser. Specific
products may carry a greater or lesser warranty but if so they will be so identified.
Replacement parts and factory repairs are warranted for a period of ninety (90) days from
date of shipment from the Edwards Company.
The foregoing shall not apply to equipment that shall have been altered or repaired after
shipment to you by anyone except our authorized employees or agents and the Company
will not be liable in any event for alterations or repairs except those made with its written
consent. Purchaser shall be solely responsible for determining suitability for use and the
Company shall in no event be liable in this respect. The equipment or parts manufactured
by others but furnished by us will be repaired or replaced only to the extent of the original
manufacturer's guarantee. No guarantee whatsoever is given as to electronic tubes, and
the Company shall have no repair or replacement obligations as to these. Our obligations
and liaibilities hereunder shall not be enforceable until such equipment has been fully paid
for. Purchaser agrees that if the products sold hereunder are resold by purchaser, he will
include in the contract for resale, provisions which limit recoveries against us in accordance
with this section. THE FOREGOING OBLIGATIONS ARE IN LIEU OF ALL OTHER OBLIGATIONS
AND LIABILITIES INCLUDING NEGLIGENCE AND ALL WARRANTIES OF MERCHANTABILITY
OR OTHERWISE, EXPRESS OR IMPLIED IN FACT OR BY LAW, AND STATE OUR ENTIRE AND
EXCLUSIVE LIABILITY AND BUYER'S EXCLUSIVE REMEDY FOR ANY CLAIM OF DAMAGES
AND IN CONNECTION WITH THE SALE OR FURNISHING OF GOODS OR PARTS, THEIR DESIGN,
SUITABILITY FOR USE, INSTALLATION OR OPERATION. WE WILL IN NO EVENT BE LIABLE
FOR ANY DIRECT, SPECIAL OR CONSEQUENTIAL DAMAGES WHATSOEVER, AND OUR
LIABILITY UNDER NO CIRCUMSTANCES WILL EXCEED THE CONTRACT PRICE FOR THE
GOODS FOR WHICH LIABILITY IS CLAIMED.
Edwards Signaling
90 Fieldstone Court, Cheshire, CT 06410
Phone: 1-203-699-3300