Altinex Pop 'N Plug Tower PNP400 - Manual (Page 4)

DESIGNER SOLUTIONS
400-0109-006 3
ABOUT YOUR PNP400 2
PNP400
POP 'N PLUG TOWER
The PNP400 Interconnect Tabletop Solution is
designed for installation into a conference room
table. The PNP400 provides a means of connecting
audiovisual, network, and power sources into a
presentation system. It is ideal for use with
ALTINEX computer video interfaces
like the
VA6804FC. The PNP400 can “pop up” into a raised
position to provide access to connectors, or it can
be lowered into a table when not in use. The
PNP400 uses a tower-type construction with a gas
spring to raise the interface into position above the
tabletop.
The PNP400 Interconnect has two openings on
either side of the unit, servicing both sides of a
table. Several optional sectional plates are
available for the following: AC power, computer
video (15-pin HD), composite video (RCA), audio
(RCA),
computer audio (3.5 mm stereo),
phone/modem (RJ-11), RS-232 (9-pin D-sub),
network (RJ-45), etc. Contact the ALTINEX Sales
Department for additional information regarding
optional connectors.
The PNP400 Interconnect is designed for use with
tables ranging from 0.25-4.0 in (6-102 mm) thick.
The PNP400 comes in a standard matte black
finish. Custom finishes for the top of the PNP400
allow the unit to accent any tabletop and are
available on a custom order basis for an additional
charge.
TECHNICAL SPECIFICATIONS 3
Specifications are subject to change.
See
www.altinex.com for up-to-date information.
MECHANICAL PNP400 (standard)
Maximum Table Thickness 4.00 in (102 mm)
Minimum Table Thickness 0.25 in (6 mm)
Height Above Table (open) 2.909 in (74 mm)
Height Below Table Surface 5.760 in (146 mm)
Base Width 6.674 in (170 mm)
Base Depth 4.840 in (123 mm)
Finish Black
T
°
Operating 10
°
C-35
°
C
T
°
Maximum 50
°
C
Humidity 90
%
non-condensing
Table 1. PNP400 Mechanical