Edwards Signaling 95 Series - Manual (Page 2)

P-047550-0898 ISSUE 9
base. Exercise care so as to not tear the gaskets that are
permanently attached to the lens and signal base.
Proceed to step 2.
2. For indoor installation, the signal may be direct surface
mounted, mounted on a 4" (102 mm) octagon box, or mounted
on 1/2" (13 mm) NPT conduit. For outdoor (weatherproof)
Figure 1. Installing the 90 Series Signals
Figure 2. Installing the 92-N5 and 95 Series Signals
(92-N5 Shown)
installation, the signal must be conduit mounted. Install the
signal base using one of the following applicable mounting
procedures.
Direct Surface Mounting (Indoor Only)
a. Remove the two-knockouts for mounting screws from
the bottom of the signal base.
b. Route the field wiring from the power source through the
conduit entrance hole in the base.
c. Fasten the base to the surface by installing two #10 wood
screws (not supplied) or other suitable hardware through
Figure 3. Installing the 92-R5 and 92-S1 Series Signals
(92-S1 Model Shown)
Lens/strobe
assembly
Clamp ring
Strobe tube
support plate
Connectors
(not supplied)
Signal base
DC Field Wiring
1/2" (13 mm) NPT
conduit (not supplied)
One of two
knock-outs for
direct surface
mounting
Gasket
the knock-out holes in the base. Proceed to step 3 for
wiring connections.
Mounting on a 4" (102 mm) Octagon Box (Indoor Only)
a. Remove the two knock-outs for mounting screws from
the bottom of the signal base.
b. Route the field wiring from the power source through
the conduit entrance hole in the base.
c. Fasten the base to the octagon box (not supplied) by
installing the screws supplied with the box through the