SilentKnight VisorAlarm Plus 2U - Manual (Page 47)

VISOR ALARM – Configuration
III - 45
Doc.DM374-I
Ver.1.0
Config>show config
; Showing System Configuration for access-level 15 ...
; VISORALARM-PLUS US Router 6 120 Version 10.6.27
log-command-errors
no configuration
description "Default configuration: VisorALARM standard"
set data-link arly serial0/0
set data-link sepi serial0/1
set data-link modem-emu serial1/0
set data-link modem-emu serial1/1
set sram-size 1024
cfg-mode binary
;
; -- Privilege Configuration --
set privilege 9 ">time" all
;
;
user manager password 24680
;
user supervisor password 13579
user supervisor access-level 9
;
user operator password 11111
user operator access-level monitor
;
network serial0/0
; -- ARLY Interface Configuration --
alarm-receiver receiver-id 6
alarm-receiver line-id 10
alarm-receiver link-test-timer 120
;
backup-alarm-receiver type secondary
backup-alarm-receiver address-main 80.26.96.183
backup-alarm-receiver sync-port 1234
backup-alarm-receiver poll-failure-time 2
backup-alarm-receiver retries-number 2
backup-alarm-receiver retry-time 2
;
supervision port 20300
supervision rate 60
;
;
serial-parameters data-bits 7
serial-parameters parity even
serial-parameters speed 19200
serial-parameters stop-bits 2
exit
;
;
protocol ip
; -- Internet protocol user configuration --
address ethernet0/0 172.28.1.30 255.255.0.0
address ethernet0/0 215.99.32.3 255.255.255.0
;
;
route 0.0.0.0 0.0.0.0 172.28.1.1 1
;
exit
;
dump-command-errors
end
; --- end ---
Config>
When a parameter is not displayed, this means it coincides with a configuration default value. The
configuration must be saved and the device restarted to activate the said configuration.