GEAR4 HouseParty Portable - Manual (Page 5)

4 GEAR4 / HouseParty Portable / User Manual
For use with iPod / iPhone /
iPad:
■ Carefully insert your iPod / iPhone / iPad into
the dock.
■ Press play on your iPod / iPhone / iPad and
control the music using your device.
■ To enable wireless control, undock your
paired iPod touch / iPhone / iPad from the
speaker and control your speaker wirelessly
through the SmartLink Wireless app.
Charging:
■ To charge your device, please make sure your
power supply is connected to the speaker.
Docking your iPod, iPhone or iPad on the
dock connector will charge your device.
■ Use the USB charge port to charge your
personal electronic devices. This is
compatible with most Smartphones, Tablets
or MP3 players with 1.5A charging.
■ Fully charging your HouseParty Portable from
empty will take about 4 hours, longer if other
items are connected.
To change to AUX mode:
■ Press and hold the power button until an
audio tone is heard (about 6 seconds). This
indicates that the mode change is successful.
■ To return to iPod mode from AUX mode,
press and hold the power button for 6
seconds or turn the speaker off and on.
For use with other audio
devices:
■ Make sure that the speaker is in AUX mode.
Please see above to change modes.
■ Plug one end of a 3.5mm audio cable (not
included) into your MP3 or MP4 player and
connect the other end into the AUX line-in
port at the back of the unit.
Power and Factory Reset:
■ The speaker will enter standby mode from on
when the power key is pressed. The power
indicator will show red.
■ If powered from the battery the unit will
automatically enter ‘storage mode’ after the
power indicator has shown red for 30
minutes.
■ Storage mode can be entered more quickly
by pressing and holding the ‘Vol –’ key about
30 seconds until the power indicator turns off.
■ To restore the speaker to its factory settings
from standby (power indicator showing red)
press and hold the power key for about 20
seconds until a beep is heard.
■ If the battery has been severely run down it
may be difficult to switch the unit on. In this
case, remove the power cable and press
the power button for 30 seconds. Re-insert
the power cable and allow to charge fully
before use.
PG532_HouseParty_Portable_Manual_V1.5.indd 4 19/06/2012 17:05