HT instruments iDM70 - Manual (Page 17)

iDM70
EN - 16
Mode “ ”
1. With the instrument in stand-by, press the key to
select the desired type of reference (see § 4.2)
2. Press the key three times to enter the indirect 3-
point measuring section. The symbol “ “ appears
on the display with side “1” flashing
3. Position the instrument in the lowest point (1) of
measurement (see Fig. 11 ) and press the key
or the side MEAS key. The result appears on the
first partial display. The symbol “ “ appears on the
display with side “2” flashing
4. Position the instrument as horizontally as possible
(2) (see Fig. 11) and press the key or the side
MEAS key to measure. The result appears on the
second partial display. The symbol “ “ appears on
the display with side “3” flashing
5. Position the instrument in the highest point (3) of
measurement (see Fig. 11) and press the key
or the side MEAS key to measure. The result
appears on the second partial display
6. The final value of the result obtained with the
combination of previous measures (see dashed line
in Fig. 11) is shown on the resulting display
7. Measuring result is automatically saved in the
instrument's memory
Fig. 11: Indirect 3-point measurement – Mode 2