In-Situ Bulkhead Connector for Use with RuggedCable Systems User Manual
Bulkhead connector
Information Sheet
TROLL
®
Accessories
(over)
Catalog No. 0053240
bULKHEAD cONNEcTOR
Nut
Gasket
Ground
contact
(brass)
Vent tube with
hydrophobic
membrane
Dust cap
RuggedCable
™
with Twist-Lock
connectors
Level TROLL,
Aqua TROLL,or
MP TROLL 9500
AppLicATiON
A panel-mounted bulkhead that mates with Twist-Lock connectors on In-Situ
RuggedCable
™
.
cONNEcTiONs & WiRiNg
1. Drill and tap hole.
• Drill bit: 29/64 (.453)
• Tap: 1/2" - 20 - NF-UNF
2. Remove jam nut and ground contact from connector assembly.
3. Thread connector assembly through drilled and tapped hole, and tighten.
4. Attach ground contact and ground it.
5. Attach jam nut and tighten.
6. Wire conductors per table below. See wiring diagrams on back of sheet.
spEcificATiONs
Output
6-wire plus ground
Environmental Rating
IP67
Wire Color
Signal
Level TROLL, TROLL 9500
Aqua TROLL
Black
GND
✔
✔
Red
EXT PWR
8–36 V
8–16 V
Blue
485(+)
✔
✔
Green
485(–)
✔
✔
Brown
4-20 mA
✔
NOT USED
White
SDI-12
✔
NOT USED*
*An adapter (catalog no. 0095200) is required for
SDI-12 operation of a TROLL 9500.