Apogee Labs 2020 - Manual (Page 7)

ETHCX1 INTERFACE CONTROLLER MODULE
APOGEE LABS, Inc. AL4300 Series
5.25.04
2020-7
Table 4 - Read Command Format
READ – Displays the current parameter setting
Command Entry Format READ <Parameter Name><CR>
System Response for Valid Command READ <Parameter Name> <Parameter Value><CR>>
System Response for an Invalid Command <CR>?
Sample Entry
System Response
READ IP Address<CR>
READ IP Address 192.168.0.10<CR>>
2020.3.3.5 SLOT Command
The SLOT command is required to permit accessing functional modules in the system. After
issuing this command the user gains access to the functions of the module contained in the
designated card slot.
Table 5 - The SLOT Command
SLOT – Accesses a selected module by its Slot number in the system
Command Entry Format SLOT=<number><CR>
System Response for Valid Command ><System Prompt>
System Response for an Invalid Command <CR>?
Sample Entry
System Response
SLOT=3
> [The user programs the module in slot 3]
2020.3.3.6 Programming Example
A typical example to control a MUX9 module located as slot 3 in the chassis is as follows:
>slot=3
>set c1id=023
>set c2id=024
>
2020.3.3.7 HELP Command
The HELP command is used to gain insight into the remote instructions associated with a
specific module. The command format and acceptable parameter value(s) are returned. The
HELP command is issued after selecting a module using the SLOT command. The ETHCX1
response to the HELP command is shown in Table 6.