KANOMAX S221-00 Handheld IAQ Monitor - Manual (Page 8)

3-3
3.4. Command Button
Measure Start:
Starts sampling in accordance with the conditions set in the measurement [Set].
When starting for the second or subsequent time, a message of “Data is not saved. Does it save?” will be
displayed if the former data has not been stored.
When [Yes] is clicked, a window for data storage will be displayed. Store the data.
To perform sampling, click [Measure Start] again.
When [No] is clicked, the previous data will be deleted and new sampling will start.
Data Transfer:
Transfers the data stored in the IAQ Monitor to the computer. When the button is clicked, the data stored in
the IAQ Monitor will be displayed. Select the data to be transferred.
Zoom On (Zoom Off):
Enables enlargement of a graph. When zooming-in a graph is enabled, [Zoom Off] button will be displayed.
When [Zoom Off] is selected, the enlarged graph will return to its initial size.
Please note that this enlargement function button cannot be used while performing a measurement.
3.5. Graph
Left Axis:
Axis of “0-550 (ppm)” shows the scale of CO.
Axis of “0-5500 (ppm)” shows the scale of CO2.
Scrolling a graph:
To scroll a graph, drag the graph to the right or left while holding down the right mouse button.
Enlarging a graph:
Select the area to be enlarged by dragging the mouse from the upper left to the right bottom while holding
down the left mouse button.
When the button is released, the enlarged graph of the desired area will be displayed.
To restore the size of the graph, click anywhere on the graph and drag to the left while holding the left mouse
button. Then release the button. Or click [Zoom Off] button.
Please note that this enlargement function button cannot be used while performing a measurement.