KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.2.48 to 3.04 - Manual (Page 28)

1-8
BOP HIPWR 101509
SAVE/RECALL CHARACTERISTICS (See PAR. 3.3.8)
Number of Locations 99
Parameters Saved or Recalled All parameters saved for power-up.
Mode of operation Voltage, Current or External For External the operating mode is deter-
mined by signal at I/O Port; no signal selects
voltage mode (see PAR. 3.4.2).
Reference type Internal, External or
External Reference Level
Main channel
Internal, External or
Lesser Limit
Limit channel
Main Amplitude
(Internal)
0 to EO
NOM
or IO
NOM
(internal or external)
Main Channel:
Voltage (Volts) for Voltage mode,
Current (Amperes) for Current mode
Protection Limit Amplitude
(Internal)
EO
MIN
or IO
MIN
to
1.01 EO
NOM
or IO
NOM
Limit Channel, Positive and Negative
Voltage (Volts) for Current mode,
Current (Amperes) for Voltage mode
Output status ON or OFF
MISCELLANEOUS FEATURES
Maximum/Minimum Settings
Protection Limit
Type
Bipolar (default) or Independent
Main Channel 0 to EO
NOM
or IO
NOM
(default) Software limit to setting of main channel
Voltage (Volts) for Voltage mode,
Current (Amperes) for Current mode
Protection Limit Channel
(maximum value, Internal)
EO
MIN
or IO
MIN
to
1.01 EO
NOM
or IO
NOM
(internal)
Software limit to setting of protection limit
channel.
Voltage (Volts) for Current mode
Current (Amperes) for Voltage mode
Load Type Settings
Active (default), Resistive,
Battery, Custom
Consult factory for custom setting.
Self-test capabilities
Display, Keypad, Interface, Serial
Interface, Analog, Output
Serial Interface test requires Loop Back Test
connector (p/o KIT 219-0436, see Table 1-5).
Interface Settings Data Format SCPI (default), CIIL
GPIB Address 0 to 30 (6 = default)
Output Status @ Reset ON or OFF (OFF = default)
Serial Baud Rate Off, 9600, 19200 (Off = default)
Device Clear SCPI (default) or MATE
XON/XOFF Enable (default) or Disable
Prompt Disable (default), Enable,
Enable with Echo
Calibration Assisted by front-panel prompts
TABLE 1-2. BOP GENERAL SPECIFICATIONS (Continued)
SPECIFICATION RATING/DESCRIPTION RATING/DESCRIPTION