KEPCO CA 33 - Manual

©2005, KEPCO, INC 1
Data subject to change without notice 228-1473 REV 1
I N S T R U C T I O N M A N U A L
KEPCO
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
An ISO 9001 Company.
CA 33
COVER
ENCLOSURES AND
HARDWARE SYSTEMS
DESCRIPTION. The Kepco Model CA 33 Cover (see Figure 1) is supplied for use with Kepco Series RKW 30 Watt
power supplies. The cover is installed by first removing two screws (M3 X 8) from the RKW power supply (see Figure
1). Then slide the cover onto the power supply, matching the tabs as shown in Detail A, and secure with screws previ-
ously removed. This screw must not be overtightened (max. torque 10 in.- lbs (1.1 N x m).
FIGURE 1. CA 33 COVER INSTALLATION
COVER TAB
SEE DETAIL A
RKW TAB
3042593-1
SEE DETAIL A
RKW 30W POWER SUPPLY
DETAIL A
RKW TAB
REMOVE EXISTING SCREWS (M3 x 8) FROM
RKW POWER SUPPLY AND USE TO SECURE
COVER TO POWER SUPPLY.
MAX TORQUE 10 1N.-LBS (1.1N x m)
CA 33 COVER
COVER TAB