KEPCO DIN KIT AK-450 (L) - Manual

©2014, KEPCO, INC 1
Data subject to change without notice 228-1798
I N S T R U C T I O N M A N U A L
KIT
KEPCO
KEPCO, INC.  131-38 SANFORD AVENUE  FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com  email: [email protected]
An ISO 9001 Company.
DIN AK
-350/450L DIN-RAIL MOUNTING KIT
FOR SERIES AK-350/AK-450
FIGURE 1. L SUFFIX ORIENTATION
INSTALLING KIT. Attach the preassembled mounting clips to the power supply using the hardware supplied (see Fig-
ure 3). The clips may be mounted with the release lever on either side to facilitate removal.
INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both clamps
under one edge of the rail, then snap the other end of the two clips into place (see Figure 2A).
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to
apply leverage towards the left as shown in Figure 2B to disengage each clip from the rail. Where mounting clips are
close together, it may be necessary to apply leverage with two screwdrivers simultaneously.
FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
TABLE 1. COMPONENTS SUPPLIED
KIT
MODEL NO.
MOUNTING PLATE
(QTY 2)
PART NO.
CLIP (QTY 2)
PART NO.
SCREW (QTY 4)
PART NO.
LOCKWASHER
(QTY 4)
PART NO.
FLAT WASHER
(QTY 4)
PART NO.
DIN AK-350/450L 128-1940 108-0362
501-0075
(M4 X 8 FLPH)
103-0017
(NO. 8, INT. TOOTH)
103-0028
(NO. 6)
A — INSTALLATION B — REMOVAL
DESCRIPTION. Kepco KIT, Model DIN AK-350/450L
contains two preassembled mounting clips and associ-
ated hardware used to install AK-350 and AK-450 Series
power supplies on a DIN rail. The “L” suffix is for mount-
ing along the long dimension (length) as shown in Figure
1. Outline dimensions are shown in Figure 4.
3043829