KEPCO EL Series USB Driver Manual - Manual (Page 4)

4
243-1296 REV 1 061510
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com email: [email protected]
8. When Hyper Terminal is launched, assign a new con-
nection name such as EL USB with the Connection
Description dialogue box, then click OK.
9. When the Connect To dialogue box appears, select the
COM port you discovered above from the pull down
menu in Connect Using and click OK.
10.Click OK for the USB port properties—USB connec-
tions do not use these properties.
11. When you click on OK you will go to the HyperTerminal
main screen, the telephone icon should be “off hook”
and you are connected to the Series EL load.
12.Typing *IDN elicits a response from the Series EL load
such as:
Kepco Inc., EL-Series,12345,MCB #102 1.64 $ 2009/02/06
15:35:41 $ Compiled Feb 06 200910:37:12.
NOTE: It is important that you do not apply power to the
EL load with HyperTerminal open because Hyper-
Terminal tends to lock up if a USB connection is
discovered after it is launched. The proper
sequence is 1) power up the Series EL, 2) plug
the USB connector into the computer (you will
hear the familiar connection gong), then 3) launch
HyperTerminal.