KEPCO HSF-PFC 100W Series Operator Manual - Manual (Page 7)

KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com email: [email protected]
083013 228-1533 REV 15
7
IV — SPECIFICATIONS (C, T, X, Y) - CONTINUED
RECOVERY CHARACTERISTICS: A step load
change from 50% to 100% produces less than +4% output
excursion. Recovery occurs to within +1% of the original
setting in <1 ms (load change t
r
or t
f
equal to or greater
than 50 µsec). (3.3V: 200mV max.)
START-UP TIME: 500 ms. maximum @100V a-c
400 ms. typical @100V a-c
300 ms. maximum @240V a-c
200 ms. typical @240V a-c
HOLDUP TIME:
37 ms. typ., 20 ms. min. (100V a-c)
30 ms. typ., 20 ms. min. (240V a-c)
DIELECTRIC STRENGTH:
Between input and output:
2KV a-c for one minute.
Between input and case (ground):
2KV a-c for one minute.
Between output and case (ground):
500V a-c for one minute.
INSULATION RESISTANCE: Between input and
ground, output and ground, input and output:
100 Megohms min. (500V d-c).
LEAKAGE CURRENT (per IEC 950 and UL 1950)
0.13mA typ. 0.19 mA maximum, (120V a-c)
0.45 mA maximum (240V a-c)
SAFETY: Units are designed to meet UL60950 3rd Edi-
tion, CSA 22.2 No. 60950-1, and EN60950:2001 and are
CE marked per the Low Voltage Directive (LVD), 73/23/
EEC and 93/68/EEC. The standards do not apply with DC
input operation.
EMI: Designed to meet FCC Class B (100-120V a-c) and
VCCI, EN55011-B, EN55022-B.
VIBRATION: (non-operating, one hour on each one of
the three axes):
5-10 Hz, 10 mm amplitude.
10-55 Hz, 2g acceleration.
SHOCK: (non-operating, one-half sinusoidal pulse, three
shocks to each axis):
Acceleration: 60g
Duration: 11ms +5ms
OPERATING TEMPERATURE: See Figure 4.
STORAGE TEMPERATURE: -30 o C to +75 o C.
RELATIVE HUMIDITY: Operating and storage: up to
95% (wet bulb temp. <35
o C non-condensing).
FUSE: Slow Blow, 3.15A, 250V; (5 x 20 mm),
Littelfuse, P/N 2153.15PF;
Kepco P/N 541-0135.
DIMENSIONS: See Figure 6.
WARRANTY: 5 years.