KEPCO KIT 219-0444, Kit for connecting three 1000W BOPs in Series - Manual

©2012, KEPCO, INC
Data subject to change without notice
228-1525 REV 3 033012
I N S T R U C T I O N S H E E T
KEPCO
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com email: [email protected]
An ISO 9001 Company.
CABLE
219-0444
KIT
CABLE KIT NO. 219-0444
BOP 1000W MODELS (3) IN SERIES
I. DESCRIPTION.
This kit contains the cables and terminations required to operate three identical 1000 Watt BOP High Power mod-
els in series, effectively multiplying the output voltage capacity by three. Only identical models may be configured
to operate in series.
This kit can be used with all 1000W BOP models that have revision levels as shown in Table 1. Earlier models
that have been upgraded to permit multiple unit configurations must include the letter “A” following the revision
number. CAUTION: Failure to install the ground cables supplied can result in damage to the power supply.
Refer to the associated technical manual supplied with the High Power BOP power supply for all instructions
regarding installation and operation of multiple units in series.
II. SPECIFICATIONS
Table 3 lists the model parameters unique to a series combination of three identical 1000W BOP Power Supplies.
Table 4 lists the general specifications for the series combinations listed in Table 3. For specifications not listed in
Table 3, refer to the General Specifications provided in the associated technical manual supplied with each
1000W BOP power supply
TABLE 1. REVISION LEVELS APPLICABLE TO THIS KIT
Model Revision
Revisions for Upgraded Units
(Must include “A”)
BOP 6-125MG All All
BOP 10-75MG 5 or higher 3A or 4A
BOP 20-50MG 8 or higher 5A, 6A or 7A
BOP 25-40MG All All
BOP 36-28MG 11 or higher 8A, 9A or 10A
BOP 50-20MG 7 or higher 5A or 6A
BOP 72-14MG 7 or higher 6A
BOP 100-10MG 6 or higher 2A or 4A
!