KEPCO RAB-40RCW1500 - Manual

©2001, KEPCO, INC
Data subject to change without notice
228-1409 REV 1
I N S T R U C T I O N S H E E T
KEPCO
KEPCO, INC. " " " " 131-38 SANFORD AVENUE " " " " FLUSHING, NY. 11352 U.S.A. " " " " TEL (718) 461-7000 " " " " FAX (718) 767-1102
http://www.kepcopower.com " " " " email: [email protected]
An ISO 9001 Company.
RAB 40-RCW1500
INSTALLATION INSTRUCTIONS
RAB 40-RCW1500 MOUNTING BRACKET
DESCRIPTION
The Kepco Mounting Bracket Model RAB 40-RCW1500 is used to mount RCW and RAX 1500W power supplies in
the RA 40 Rack Adapter. The RAB 40-RCW1500 consists of two mounting brackets and associated hardware.
INSTRUCTIONS (Refer to Figures 1 and 2.)
Attach power supply to mounting brackets using “B” holes and hardware indicated in Table 1 (see Figure 1 for loca-
tion) and hardware supplied with power supply. Remove the front and rear panels of the rack adapter (screws “C”
Figure 2) Then attach mounting bracket to rack adapter rails (front and rear) using holes marked “A” in Figure 1.
Reinstall front and rear panels on rack adapter. Figure 2 shows power supply after installation.
FIGURE 1. KEPCO MOUNTING BRACKET MODEL RAB 40-RCW1500
TABLE 1. PARTS LIST
PARTS SUPPLIED
ITEM KEPCO P/N
Use Holes
(see Figure 1)
PART FUNCTION
Mounting bracket Mount RCW or RAX 1500 watt power sup-
ply to RA 40 rack adapter (2) Bracket 128-2074
Hardware (power
supply to mounting
bracket) Hardware to attach RCW* 1500 power
supply to mounting brackets. (8) Machine Screws (M4 x 8) 501-0081 B
(8) Int. Lock Washers (#8) 103-0017 B
(8) Flat Washer #8 103-0062 B
Hardware (mounting
bracket to rack
adapter) Hardware to attach RAB 40-RCW1500
mounting brackets to RA 40 rack adapter (8) Machine Screws (6-32 x 1/2, RHPH) 101-0154 A
(8) Flat Washers (#6) 103-0028 A
(8) Int. Lock Washers (#6) 103-0015 A
* Two brackets required to install RCW and RAX 1500 watt power supplies.