ADTRAN 600 Series - Manual (Page 40)

Total Access 600 Series User Manual © 2002, ADTRAN, Inc.
Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 40
RIP
Use this menu to enable RIP on the WAN interface. (See RIP on page 37 for description of options.)
RFC 1483 Bridge
This is used to enable bridge mode on this PVC. (These settings only take effect when RFC 1483 is the
selected protocol.)
PPPoATM
The Total Access 600 uses the PPPoATM profile to specify the profile used when connected using PPP.
Authentication
The authentication menu contains the required parameters for the authentication of the PPP peer and for
being authenticated by the PPP peer. Authentication is applied between the Total Access 600 and the
PPP peer as follows:
TX Method
This parameter specifies how the Total Access 600 is to be authenticated by the PPP peer. There are four
possible selections.
P RIVATE A DDRESS
M ODE
The private IP address can be specified to steer
certain protocols and ports to specific servers in
the private network. Likewise, internal hosts can
be steered to certain servers on the public
network. A new request from the public network
matching this entry’s public parameters will be
dropped if this mode is set to
$ 1< , 17(51$/ .
P RIVATE P ORT
M ODE
The private destination port associated with this
entry can be specified to add more control over
certain types of traffic. Leave as
$ 1< 3 257 to
cover all port types.
T RANSLATE B ODY By default, the application payload in the packet
is scanned for occurrences of the private/public IP
address in binary or ASCII form. Set this to
1R for
applications where this will cause problems.
NAT V IEW Shows the protocols that are actively being translated.
NAPT A DDRESS Represents the public address that is being used as the
NAPT address.
E NTRY C OUNT The number of entries in the NAT table.
E NTRY O VERFLOW
C OUNT
A count of the dropped entries due to low memory.
N ONE (def) The connection will not allow the PPP peer to authen-
ticate it.
P AP , C HAP , OR E AP The connection can be authenticated using PAP,
CHAP or EAP.
C HAP OR E AP The connection can be authenticated using CHAP or
EAP only.
E AP The connection will only allow authentication by the
peer using EAP.