KROHNE OPTISENS PH 8100 EN - Manual (Page 17)

INSTALLATION
3
17
OPTISENS PH 8100
www.krohne.com 03/2012 - 4001925901 MA OPTISENS PH 8100 R01 en
3.7 Installing the sensor
3.7.1 General installation instructions
The electrode tip must always have full contact with the measuring medium.
The mounting position of the electrode should not deviate more than 75° from vertical position
(electrode tip pointing downwards). Doing otherwise might cause internal air bubbles to float
into the electrode's glass tip. This would interrupt the electrical contact between the inner buffer
solution and the glass surface.
Figure 3-7: Installation requirements
1 Measuring medium
2 Maximum deviation of 75° from vertical position
.book Page 17 Wednesday, July 4, 2012 11:07 AM